羅茨鼓風機無法運行的原因有哪些

羅茨鼓風機應用很廣泛,但是羅茨鼓風機存在故障時, 不要使用，一般鑄鐵三葉羅茨風機進 氣溫度超過40攝氏度,三葉羅茨風機就會出現問題。下面小編要為大家介紹下導致羅茨鼓風機無法運行的四個原因。

Roots blower is widely used, but when roots blower has faults, do not use it. Generally, if the intake temperature of cast iron three blade roots blower exceeds 40 ℃, three blade roots blower will have problems. The following small series to introduce to you the four reasons for Roots blower can not run.

1、機械故障

1. Mechanical failure

存在故障時,不要使用,即便有輕微故障,有些客戶風機存在故障,某些廠家要求客戶繼續運行使用,運行壞了之后重新采購新的,有些客戶可能會遇到過,這種情況。

Don't use it when there is a fault. Even if there is a slight fault, some customers have a fan fault, and some manufacturers require customers to continue to use it. After the operation is broken, they purchase new ones. Some customers may encounter this situation.

2、輸送氣體有毒

2. The gas transported is poisonous

有毒的氣體一般不會使用三葉羅茨風機進行輸送 , 在即便是特殊密封,危險性也比較大。

Toxic gases are generally not transported by a three blade roots blower, and even in a special seal, it is more dangerous.

3、進氣溫度超過40度

3. The intake air temperature exceeds 40 ℃

一般鑄鐵三葉羅 茨風機進氣溫度超過40攝氏度,三葉羅茨風機就會出現問題,所以,進溫度超過40攝氏度，一般三葉羅茨風機無法正常運轉。

Generally, if the inlet temperature of cast iron three blade roots blower exceeds 40 ℃, the three blade roots blower will have problems. Therefore, if the inlet temperature exceeds 40 ℃, the general three blade roots blower cannot operate normally.

4、輸送氣體易燃易爆

4. The transported gas is flammable and explosive

輸送氣體易燃易爆需要三葉羅茨風機進行特殊處理,沒有做過特殊處理的三葉羅茨風機禁止輸送。

The inflammable and explosive gas to be transported needs special treatment of the three blade roots blower, and the three blade roots blower without special treatment is forbidden to transport.